Recently purchase an 82 Fl 250. When purchased rhe pull start was broke. I was told at time of purchase that the gas had water in it recently. The previous owner flushed the old gas and put in new.
I fixed the pull cord however cant get it to start.
It will run with gas in the cylinder and cuts out after a few seconds.
I have cleaned the carb 3 times pulled jets checked float etc. Replaced the spark plug and have good spark. Purchased a compression tester and have 120 psi. The carb seems to be getting gas through the lines every time I remove to clean there is gas in carb. Also have disconnected fuel line and pulled and gas pumps through the lines. Any thoughts anyone has would be greatly appreciated.
