« previous next »
Pages: 1 2 3 [4]

Author Topic: FL250 Assembly Thread  (Read 21776 times)

odypilots

  • Sr. Member
  • ****
  • Posts: 345
  • Karma: 6
    • View Profile
    • Downhomeracing.com/opr
Re: FL250 Assembly Thread
« Reply #45 on: August 19, 2013, 08:46:36 AM »
Man, that looks good!
Logged
The usual 'my two cents' disclaimer applies. :)

Robin Hood

  • Newbie
  • *
  • Posts: 7
  • Karma: 0
    • View Profile
Re: FL250 Assembly Thread
« Reply #46 on: August 31, 2013, 01:51:57 PM »
Quote from: cd on December 03, 2012, 09:31:50 AM
More:

How did you get the intake connected to the air cleaner? Also did you run a tee fitting in the line with a return to the gas tank? Thanks!
Logged

Casey Davis

  • Newbie
  • *
  • Posts: 16
  • Karma: 0
    • View Profile
Re: FL250 Assembly Thread
« Reply #47 on: September 08, 2013, 01:15:19 AM »
The "rubber intake tube" from the intake (motor side) connects to the carburetor and the "rubber connector tube" connects the carburetor to the air cleaner base. Hose clamps were used to secure both. Note: The "rubber connector tube" used is from NAPA. The stock FL250 rubber connector tube will not fit this aftermarket carburetor.

I used something similar to a "tee". What was used is a HONDA "check valve", same as they came with originally.
Logged
Pages: 1 2 3 [4]
« previous next »