Author Topic: Front brake conversion  (Read 2188 times)

oleskool

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
    • View Profile
Front brake conversion
« on: December 07, 2016, 10:55:51 PM »
So have been reading on the disk brake conversion for FL350, and everything has said to use 400ex hubs are a direct fit. My question is how are you getting the caliper to mount?

girth first

  • Jr. Member
  • **
  • Posts: 94
  • Karma: 1
    • View Profile
Re: Front brake conversion
« Reply #1 on: December 13, 2016, 10:42:34 PM »
It would be alot cheaper to remove the old rubber brake lines and replace them with stainless steel lines. I am 250lbs and after i did that swap i have 0 promblems with the braking, i can lock um up or feather it down with no worrys the way it used to be with rubber lines it was a suggestion to stop, but i often over shot my target. I know this doesn't answer your question but if your replacing this set up because Oddy wont stop this is a viable option.