Tom, do you have a stock travel pilot too? Does the stock one see the same angles as the LT?
Their inners are a bit different, the cup is a bit longer (1/4"?) and so they shortened their axle a bit (again 1/4"?) They assured me it would be fine, just changes where the joint sits in the cup, therefore although they fit on, you can't use their CV's on stock axles, the CV would probably then bottom out in their cup.
I can get complete axles made $250USD each, if I order 20. Minimum is 20 due to the fact that they have to make the outer CV, the have the internals, but not a stub with the same spline to fit the wheel hub. They had one with the same spline count, but the pitch was different, so the it wouldn't fit
So I'm running my same outers on their inner/axle combo. I'd like to have new outers as well. I had gotten 4 used ones...got 2 off to keep as spares...one was ruined in getting it off, and one had a cracked cage.
I'm not going to stock any of these, and it will probably be a one time deal. I can't see another buy happening after this one...that's if I get orders for....I'll take 6 for our 3 pilots here..so if I get orders for 14 more axles ($250USD+shipping) I'll put the order in.
They can do LT's as well if someone can send in an axle so they can get the measurements from one, I am 90% positive for the same price. If anyone wants LT's I'll verify that.
Reply here so I get an idea whether or not to pursue this.