Honda Odyssey and Pilot Forum

Please login or register.

Login with username, password and session length
Advanced search  

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - steves1983fl250

Pages: [1]
1
Odyssey FL250 / Parts question
« on: June 04, 2009, 12:24:40 AM »
I heard that comet makes a good clutch setup for the oddessy, anyone use one?? What other clutch place like Dalton or somebody else is there?? Also whats the correct belt for the 83fl250?? I can compress the clutch spring with my hand is that bad? i know you cant do that on my snowmobile, so i figured time for a clutch rebuild. Also i would like to get a new plug wire and coil, i think it dont always get enough spark. i adjusted the carb right, the needle clip was at the top i put it in the 2nd groove, someone said in the middle, but it seemed to run better in the 2nd. i adjusted mixture 1 3/4 turns, sometimes its har to start, i can see fuel in filter, then sometimes it wont idle for crap, and most of time it has a bog when you first take off. i dont know if week spark? I was thinking maybe clutch  so wore out that it cant burn the fuel it gets when you give it gas. i can see my belt rubbed a clean spot on my axle, so i am sure its time for a new belt. I see Tractor supply has the correct air filter for it, i see alot of belts that look close, i want to compare numbers. I want to make the oddessy reliable so me and the wife cant ride worry free. thanks in advance :)

2
Odyssey FL250 / clip on needle jet
« on: May 21, 2009, 11:10:17 PM »
I was alos wondering what slot the clip should be on in the needle jet? I havent had it long but trying to dial it in more, it runs good, just gotta get new plug, and i think adjust the carb. Need to know what the air fuel screw should be set at?  :D

3
Odyssey FL250 / What is the correct spark plug to run
« on: May 21, 2009, 10:58:17 PM »
I was just wondering what is the correct sparkplug for the 1983 FL250 oddessy? Whats the gap set at also? Also how many turns should the air fuel mixture screw be at? To start at Baseline anyway? Thanks i am a newbie to the site! :D

4
General Discussion / Parts for 1983 FL250 oddessy
« on: May 09, 2009, 12:10:38 PM »
Hi i am new to the site and just purchased a 1983 fl250 oddessy in good condition, i was wondering where to buy parts, such as different color or same color fenders, wheel bearing, drive belt etc. Also clutch parts, i would like to change the weights helix to wake it up a little more, it runs and get speed great, but i am sure the clutch needs rebuilding, never been rebuilt. So i am sure spring in clutch wore out plus i want to pep up the clutch anyway. i am very familair with the clutching because i have snowmobiles. Also want new rollbar padding. I have a chance to get 2 other oddesy's minus motors but everything else is there, how easy and cheap is it to get motors for them or convert to snowmobile motor which i see alot of people using? thanks

Pages: [1]