Honda Odyssey and Pilot Forum
General Category => Commerce => For Sale: => Topic started by: PilotHawK on April 07, 2009, 03:58:32 PM
-
I had custom input shafts machined for my pilot project, and since I am no longer pursuing it they aren't doing me any good. The shafts are 16" overall with 10" of usable input shaft for the driven clutch.
I paid a hefty sum to have these machined to exactly fit the honda pilot transmission. I needed a new shaft with an industry standard size instead of the honda specific splines. With the 1" shaft I could use a wide variety of snowmobile clutches with my conversion.
Input shaft 16" overall, 10" of usable shaft for the driven clutch that is 1" in diameter with a 1/4" keyway.
This is exactly waht you need if you are planning on doing a sled engine conversion on your pilot. I have 2 of these and I want $250 each which will include shipping.
These parts are beautifully machined, and cost way more to have done than I'm asking.
-
$200 each
-
Heat treated ?
-
very gently :) As far as I know they are not heat treated. The material they are machined from is supposed to be especially suited for this type of application.
odypilots is running this same type of shaft in his 600 sled powered buggy.
-
I'll take one if you still have them. Whats your number?