Honda Odyssey and Pilot Forum

General Category => General Discussion => Topic started by: digatech on August 05, 2005, 01:09:03 PM

Title: Grounding your Digatron sensors
Post by: digatech on August 05, 2005, 01:09:03 PM
For your Digatron instrument to work correctly you need to insure that all sensors with ground leads are grounded to the engine block. The engine block is the ground for all the electrical for your engine. This ground can be different from the chassis ground, which may cause electrical noise (erratic reading) to be displayed on your instrument. So if you are getting erratic sensors reading always check to see that you have a good clean engine block ground.

Digatron Technical Support