Honda Odyssey and Pilot Forum
General Category => Pilot FL400R => Topic started by: lucky luciano on March 18, 2010, 01:07:45 PM
-
drove five hours out and back from 1pm to 1am to get an 89 pilot, completely stock, except the guy had the engine completely rebuilt and bored .20 over.. landed it for 3200 ;D. any suggestions for mods? i want to get as much torque and throttle response as i can get.. I'm riding trails in the northeast, so i don't need a really high top speed, but i wanna get up to top speed as fast as possible.
any disc brake conversion possibilities?
does anyone make stock front a-arms for the pilot with replaceable/adjustable ball-joints?
thanks for any advise!
-
drove five hours out and back from 1pm to 1am to get an 89 pilot, completely stock, except the guy had the engine completely rebuilt and bored .20 over.. landed it for 3200 ;D. any suggestions for mods? i want to get as much torque and throttle response as i can get.. I'm riding trails in the northeast, so i don't need a really high top speed, but i wanna get up to top speed as fast as possible.
any disc brake conversion possibilities?
does anyone make stock front a-arms for the pilot with replaceable/adjustable ball-joints?
thanks for any advise!
only adjustable ball joint a-arms I know of are aftershockmotorsports as far as torque and throttle response I would lower the gearing by running a smaller tire although you give up ground clearance doing this.
-
If you have to pull the engine apart, A mild porting of the cylinder really wakes up the Pilot.
-
I know of a couple of good places to get it ported too