((((SOLD)))) I have a nice Honda Odyssey FL350 for sale. Im selling it to make room for a Pilot. This Odyssey is in great condition mechanically and cosmeticly. Theres a lot invested in this machine, most every part that was worn or not within the Honda service manual spec was either replaced or rebuilt... Well, here goes... Ill just start with the motor.....New motor top end with 80.5mm Wiseco piston, wrist pin and rings, lubrication holes placed in correct area on the piston, rings have proper end gap after installation, exhaust bridge relieved, skirt beveled, all ports chamfered properly, motor castings cleaned. Bottom end rebuilt using all new NTN C3 rated bearings, all new Honda oil seals, new Honda gaskets, all bolts properly torqued when reassembling motor, compression is 130lbs. New fuel pump, new Mossbarger reed spacer, new V force 3 reeds petals, fuel/pulse lines have been replumbed, carburator properly jetted, K&N air filter and water resistant outerware, motor has bladder modification to prevent oil from getting to the starter, starter rebuilt with Honda parts and working properly, water cooled head installed with fan, water pump, water temp gauge, Digitron EGT / TACH meter. Reverse rev limit modification performed. Motor has about 10 to 15 hours on the rebuild.This motor really hauls. No transmission or motor leaks. New Comet 94c drive clutch, Works shocks on the rear (front shocks are stock), new bushings and seals on front "J" arms, new heavy duty tie rods and new ends installed, new front wheel bearings, new throttle cable, front and rear brake shoes/pads replaced, brake system fluid flushed. Odyssey was lubed to Honda manual specs. Both the driven and drive pulleys shift properly.Transmission shifts and functions properly. All electrical switches were cleaned and properly lubricated, good paint, front fenders and tub are perfect, rear fenders have a few cracks that have been repaired. Seat was reupholstered and more padding added in the butt area, new wrist straps, seatbelts/harnesses are all in good shape. You can pick sand or dirt tire combination. The sand tires are mounted on the machine right now, the rear sand tires are in ok condition and the front sand tires are almost new, all are mounted on aluminum rims. The dirt tires are mounted on the stock Honda gold rims. Honda HP2 was used for the oil/gas mix at 32:1. Motor balancer oil and transmission oil changed seasonal. This machine needs nothing and is ready to go to the dunes. Im sure Im leaving something out so if you have any questions just ask, my email address is
[email protected] .This Odyssey must be picked up here in Oklahoma City, Oklahoma. Price $3500. ((((SOLD))))
Author
Topic: Honda Odyssey FL350 for sale good condition ((((SOLD)))) (Read 2513 times)