Author Topic: little help on rebilding 350  (Read 2291 times)

bpbaggins

  • Newbie
  • *
  • Posts: 11
  • Karma: 0
    • View Profile
little help on rebilding 350
« on: August 23, 2004, 05:46:11 PM »
I'm starting to rebuild my daughters 350. i'm looking for more low end, she's not as hot on the gas as we are. stock with a comet 102. thank's
In enjoy the day, were not taking the dirt nap!    :D

Odyknuck

  • Full Member
  • ***
  • Posts: 119
  • Karma: 2
    • View Profile
little help on rebilding 350
« Reply #1 on: August 23, 2004, 08:13:38 PM »
The 102 is primarlly designed for racing. What color is the spring in the 102C. The clutch normally comes with a yelow (older models) or purple  (newer models). This gives the clutch a 4600 RPM stall speed. If you use a pink spring it will put it closer to stock at around 3100 RPM.  Putting smaller diameter tires on the rear will allso give the buggy more low end while sacrificing top end witch sounds like what you want anyway. The cylinder can be ported for a more torque low end however the cost may not be worth it to you. I would go with the clutch spring  and tires first to see if that fits your needs.

bpbaggins

  • Newbie
  • *
  • Posts: 11
  • Karma: 0
    • View Profile
little help on rebilding 350
« Reply #2 on: August 25, 2004, 03:52:44 PM »
I was reading on hoser site about reed cage modifications and i've done a lot of head porting on cars i was going to clean up the seam lines an gasket match.he also made reference to the exhaust port clearance.is there anything else i should look out for?
In enjoy the day, were not taking the dirt nap!    :D

bpbaggins

  • Newbie
  • *
  • Posts: 11
  • Karma: 0
    • View Profile
little help on rebilding 350
« Reply #3 on: August 25, 2004, 03:53:44 PM »
and thanks for your help
In enjoy the day, were not taking the dirt nap!    :D

atvnut

  • Full Member
  • ***
  • Posts: 130
  • Karma: -1
    • View Profile
little help on rebilding 350
« Reply #4 on: September 20, 2004, 06:58:39 AM »
just for some FYI you might want to read this.

http://www.aftershockmotorsports.com/350rebuild/
Thank you
"The Nut"

bpbaggins

  • Newbie
  • *
  • Posts: 11
  • Karma: 0
    • View Profile
little help on rebilding 350
« Reply #5 on: September 21, 2004, 06:30:23 PM »
I read this awile ago, great info. Can you think of anything about porting. I'm going to clean up the seams and casting. this should help the low end toque. Thanks for the info!
In enjoy the day, were not taking the dirt nap!    :D