Author Topic: CR250 odyssey motor.  (Read 1387 times)

PilotHawK

  • Hero Member
  • *****
  • Posts: 616
  • Karma: 0
    • View Profile
CR250 odyssey motor.
« on: June 26, 2008, 02:07:14 AM »
I have a stock bore (70mm) 73-74 CR250 top-end mated to an odyssey bottom end, complete with CDI stator plate and flywheel, intake and exhaust manifolds, and primary clutch, but no pull starter.

This engine has 0 hours since rebuild and was put together with honda bearings, gaskets, and seals. The piston is a stock bore CR250 wiseco piston.

$350 plus shipping will get this motor. If no one picks this up in a few days I will list just the top-end on fleabay.

aas5f6

  • Jr. Member
  • **
  • Posts: 71
  • Karma: 0
    • View Profile
Bottom End
« Reply #1 on: July 10, 2008, 08:09:02 AM »
Do you possible have a bottom end rebuild without electronics. I have a points system on mine now. I just want a good bottom end.